The DncDaq component can be set from the standard Visual Studio property window, but it has its own setting screen.
For showing the setting screen, please see Set the component properties.
From this setting screen, it is possible to perform device settings, timing settings, input task settings, and output task settings.
The general explanation of the setting screen is shown below. For the explanation of each tab, please refer to each screen explanation page.
①Various setting pages
Displays the device settings, timing settings, input task settings, and output task settings pages.
For details on each tab page, please refer to each explanation page.
②Mode display
The display changes as follows depending on the current DncDaq mode.
You can also change the mode by clicking this label.
・Basic mode
・Advanced mode
③Export button
Displays a dialog to save the setting information being edited in the ini file format (xxx.ini).
④Import button
Displays a dialog to specify the ini file format (xxx.ini) to be read.
⑤Mode Change button
Switches between Basic mode and Advanced mode.
When you switch to Advanced mode while setting Basic mode, the Basic mode setting is remembered,
but if you click the OK button after switching to Advanced mode, the Basic mode setting will be cleared. Please note.
⑥OK button
Saves the settings and close the DncDaq settings screen.
⑦Cancel button
Closes the DncDaq settings screen without saving the settings.