Set the I/O address and interrupt level in the following range to avoid conflict with your system. Parameter setting for the board must match the setting made with Setup of Property.
I/O address
0020H-FFF0H
Set the I/O address using the switch, SW1 and SW2. The factory default setting is 0300H.
Interrupt level
IRQ3-7, 9(2)-12, 14, 15
No hardware setting is necessary for the card.
A system can be made to recognize a resource in WindowsXP/2000/Me/98SE/98/95 using an information file.
Please refer tp Resister board.
A setup of the board at the time of shipment is shown below.