Select to stop waveform output with synchronization control signal
If you want to match the stop timing of multiple boards, set it from the slave side via this VI
ExtSignal |
Initial value: 0 (Synchronous Control Signal 1) |
[Essential]
Specify the number of the synchronization control signal used for sampling
stop
0
: Synchronous Control Signal 1
1 : Synchronous Control Signal
2
2 : Synchronous Control Signal
3
* In synchronous operation, it is the slave device that selects the synchronous control signal for the stop setting
* Synchronous Control Signal 3 is the recommended setting when synchronous control signal is used for stop