Select to stop generating of digital output with synchronization control signal
If you want to match the stop timing of multiple boards, set it from the slave side via this VI
ExtSignal |
Initial value: 0 (Synchronous Control Signal 1) |
[Essential]
Specify the number of the synchronization control signal used for sampling
stop
0
: Synchronous Control Signal 1
1 : Synchronous Control Signal
2
2 : Synchronous Control Signal
3
* In synchronous operation, it is the slave device that selects the synchronous control signal for the stop setting
* Synchronous Control Signal 3 is the recommended setting when synchronous control signal is used for stop