Select to stop sampling of counter input with synchronization control signal
If you want to match the stop timing of multiple boards, set it from the device side via this VI
CntStopMode |
Initial value: 4 (synchronous stop) |
Specify whether to stop the counter synchronously when sampling stops
3:
Counter asynchronization stop
4: Counter synchronization stop
CntStopChannelNum |
Initial value: 1 |
Specify the number of channels to count when sampling
It is specified from Ch 0 with consecutive
number of channels
For example, if 2 is specified, it becomes Ch 0, Ch 1 setting
This value is used by the driver to set the counter stop condition of each channel
ExtSignal |
Initial value: 0 (synchronization control signal 1) |
[Essential]
Specify the number of the synchronization control signal used for sampling
stop
0
: Synchronization control signal 1
1 : Synchronization control signal
2
2 : Synchronization control signal
3
* In synchronous operation, it is the slave device that selects the synchronous control signal for the stop setting
* Synchronization control signal 3 is the recommended setting when synchronous control signal is used for stop