Select to start outputting waveform with synchronization control signal after start VI is executed
If you want to synchronize the start timing with multiple boards, make settings with this VI at the slave side
ExtSignal |
Initial value: 0 (Synchronous Control Signal 1) |
[Essential]
Specify the number of the synchronization control signal to be used to
start waveform output
0
: Synchronous Control Signal 1
1 : Synchronous Control Signal
2
2 : Synchronous Control Signal
3
* In synchronous operation, it is the slave device that selects the synchronization control signal for the trigger setting
* The recommended setting when synchronization control signal is used at start is Synchronous Control Signal 2