Select to start sampling of counter input with synchronization control signal after start VI is executed
If you want to synchronize the start timing with multiple boards, make settings with this VI at the slave side
CntStartMode |
Initial value: 4 (synchronous start) |
Specify whether to start the counter synchronously at the start of sampling
3:
Counter asynchronization start
4: Counter synchronization start
CntStartChannelNum |
Initial value: 1 |
Specify the number of channels to count when sampling
It is specified from Ch 0 with consecutive
number of channels
For example, if 2 is specified, it becomes Ch 0, Ch 1 setting
This value is used by the driver to set the counter start condition of each channel
ExtSignal |
Initial value: 0 (synchronization control signal 1) |
[Essential]
Specify the number of the synchronization control signal to be used for
sampling start
0
: Synchronization control signal 1
1 : Synchronization control signal
2
2 : Synchronization control signal
3
* In synchronous operation, it is the slave device that selects the synchronization control signal for the trigger setting
* The recommended setting when synchronization control signal is used at start is synchronization control signal 2