In DAQ-LV-WIN Ver 1.10, several VIs' names have been changed.
Therefore, when opening an application that uses the corresponding VI of
the previous version, a search dialog is displayed.
In this case, please follow the steps below to select the changed VI.
After saving in 4, the search dialog will not be displayed in the same
application.
1. Select [Instance.llb] in the [user.lib - _ CONTEC] folder under the LabVIEW directory and click OK
2. Please refer to the table below, select the changed VI and click OK
Searching file |
VI after change |
ai_sample.vi |
ai_timing.vi |
ao_sample.vi |
ao_timing.vi |
ai_stop_com.vi |
ai_stop_soft.vi |
get_ai_stats.vi |
ai_status.vi |
get_ao_stats.vi |
ao_status.vi |
ai_trigger_InRange._ex.vi |
ai_trigger_InRange_ex.vi |
aio_filtrer.vi |
aio_filter.vi |
3. A warning appears because the VI name to be used has been changed
4. Please save after the application opens
Follow the tutorial's [Install] procedure to make sure that DAQ-LV-WIN has been successfully installed.
You can isolate the cause by opening the sample VI of DAQ-LV-WIN.
If you open the sample without any problem, it may be that you cannot find
a VI other than the one prepared by DAQ-LV-WIN.
Please check the VI name displayed in the search dialog.