SmcWGetZCountMotion


Function

Retrieves the setting of the each mode of Z-phase count motion.

Format

Ret = SmcWGetZCountMotion( Id, AxisNo, ZMoveCount, ZLog )

Parameters

Id [ VB.NET: Short ] [ C, C++: short ] [ C#: short ] [ Python: ctypes.c_short ]
SSpecify the Deice ID retrieved by SmcWInit function.

AxisNo [ VB.NET: Short ] [ C, C++: short ] [ C#: short ] [ Python: ctypes.c_short ]
Specify the axis number.

ZMoveCount [ VB.NET: Short ] [ C, C++: short * ] [ C#: out short ] [ Python: ctypes.POINTER(ctypes.c_short) ]
Specify the address of a variable to store the number of Z-phase.

ZLog [ VB.NET: Short ] [ C, C++: short * ] [ C#: out short ] [ Python: ctypes.POINTER(ctypes.c_short) ]
Specify the address of a variable to store the logic of origin input.
 0:Falling edge
 1:Rising edge

Return Value

Ret [ VB.NET: Integer ] [ C, C++: long ] [ C#: int ] [ Python: ctypes.c_long ]

0

Terminated normally

Non-zero

Terminated abnormally

See also: Error code details

Remarks

It is not possible to use it by the SMC-2/4/8DL series.

This function can be executed even if the axis is in operation.

See Also

SmcWSetZCountMotion