Sets the stop number for stop condition.
Ret = DioDmSetStopNumber ( Id , Direction , StopNumber )
Id
[ VB.NET: Short ] [ C, C++: short ] [ C#: short ] [ Python: ctypes.c_short
]
Specify the device ID retrieved from DioInit.
Direction
[ VB.NET: Short ] [ C, C++: short ] [ C#: short ] [ Python: ctypes.c_short
]
Set the transfer direction.
Definition |
Value [Dec] |
Description |
DIODM_DIR_IN |
1 |
Input |
DIODM_DIR_OUT |
2 |
Output |
StopNumber
[ VB.NET: Integer ] [ C, C++: unsigned long ] [ C#: uint ] [ Python: ctypes.c_ulong
]
Set the stop number.
Device Type |
Available range |
DIO-32DM3-PE |
1 =＜ StopNum =＜ 536,870,912(20000000H) |
PIO-32DM(PCI) |
1 =＜ StopNum =＜ S6,777,215(FFFFFFH) |
Ret [ VB.NET: Integer ] [ C, C++: long ] [ C#: int ] [ Python: ctypes.c_long ]
Definition |
Value [Dec] |
Description |
DIO_ERR_SUCCESS |
0 |
Normal completed. |
DIO_ERR_SYS_RECOVERED_FROM_STANDBY |
7 |
Execute DioResetDevice function because the device has recovered from standby mode. |
DIO_ERR_DLL_INVALID_ID |
10001 |
Invalid ID specified. |
DIO_ERR_DLL_CALL_DRIVER |
10002 |
Not call the driver (Failure on DEVICE I/O CONTROL). |
DIO_ERR_SYS_NOT_SUPPORTED |
20001 |
This board couldn't use this function. |
DIO_ERR_SYS_IODIRECTION |
20500 |
Direction value is out of range. |
DIO_ERR_SYS_STOP_NUM |
21006 |
Stop number is outside the setting range. |
The others (See also: Details of Error Code)
The default is 1000.
It is necessary to call this function when stop number is specified as stop condition.
Sets the stop number to 10000 for input transfer.
VB.NET |
Dim Ret As Integer |
C, C++ |
long Ret; |
C# |
int Ret; |
Python |
Ret = ctypes.c_long() |