Address Commands

- GTL (GO TO LOCAL(01H))

  Sending this command sets the destination device to a local state.
  Please refer "GPIB Command Bus Line" to know the timing of bus-line.

- SDC (SELECT DEVICE CLEAR(04H))

  Sending this command sets the destination device to its initial state.

  Please refer "GPIB Command Bus Line" to know the timing of bus-line.

- PPC (PARALLEL POLL CLEAR(05H))

  Sending this command sets the response bit for the parallel poll feature of the device.

- GET (GROUP EXECUTE TRIGGER(08H))

  Sending this command sets the trigger for the destination device.

  Please refer "GPIB Command Bus Line" to know the timing of bus-line.

- TCT (TAKE CONTROL(09H))

  Sending this command allows you to specify the destination device as the active controller.