|
Common Functions |
|
| ZmInit | Retrieve the device ID, then the device can be accessed. |
| ZmExit | It is exit processing, and makes the device cannot be accessed. |
| ZmResetDevice | Reset a device. |
| ZmGetErrorString | Retrieve the error string from the error code. |
|
Information Acquisition Functions |
|
| ZmQueryDeviceName | Retrieve the list of available devices. |
| ZmGetMaxChannsels | Retrieve the maximum number of channels for the device. |
|
Setting Functions |
|
| ZmSetFrequency | Set the measurement frequency. |
| ZmGetFrequency | Get the measurement frequency. |
| ZmSetLevel | Set the measurement signal level. |
| ZmGetLevel | Get the measurement signal level. |
| ZmSetSpeed | Set the measurement speed and average count. |
| ZmGetSpeed | Get the measurement speed and average count. |
| ZmSetCircuit | Set the equivalent circuit mode. |
| ZmGetCircuit | Get the equivalent circuit mode. |
| ZmSetRange | Set the measurement range. |
| ZmGetRange | Get the measurement range. |
| ZmCorrection | Perform the correction. |
| ZmSetCorrectionEnable | Enable/disable the correction. |
| ZmGetCorrectionEnable | Get the enable/disable of correction. |
| ZmSetCorrectionValue | Set the correction value. |
| ZmGetCorrectionValue | Get the correction value. |
| ZmSetStartDelay | Set the measurement start delay time. |
| ZmGetStartDelay | Get the measurement start delay time. |
| ZmSetSignalOutputDelay | Set the measurement signal output delay time. |
| ZmGetSignalOutputDelay | Get the measurement signal output delay time. |
| ZmSetTriggerSyncEnable | Enable/disable the trigger synchronous output. |
| ZmGetTriggerSyncEnable | Get the enable/disable of trigger synchronous output. |
| ZmSetContactCheck | Set the contact check function. |
| ZmGetContactCheck | Get the contact check function. |
|
Measurement Functions |
|
| ZmSingleCMeasure | Perform a C (Capacitance) measurement only once. |