This section shows the S Rate of the time-speed characteristics curve shown below.
You can set the S Rate within a range of 0 through (target speed-start speed) / 2.
The following positive results of setting up an S Rate (servo motor) have been reported:
- We use the S Rate with image processing. Since the rate reduces vibrations when stopping, we were able to reduce blurring significantly during shooting.
- We use the S Rate for chip dispensers. Since the rate reduces vibrations when stopping, we were able to resolve the problem of falling chips during transfer.
Contec also received the following comments:
- We introduced the S Rate but there was no effect (not necessary).
- Introduction of the S Rate resulted in a longer positioning time (not necessary).
The optimum value of the S Rate must be determined by the customer. Please note that Contec cannot provide support in this matter.