[#]:Select device

Select the device for which you want to change the DeviceName.
At the "Please input" prompt, specify the number in [] of the target device.
Enter the number of the target device, information about the selected device will be displayed, and wait for command selection.

The commands that can be executed depend on the target device.

Change DeviceName

Select the command "[1]:Change DeviceName" to change the DeviceName of the selected device.
Select the command "[m]:Back to menu", the (Devices list) menu will be displayed again, and wait for command selection.
It can not have the same name as any other device.
When specifying a device from an application, specify this DeviceName.

Network settings

Configure the wired LAN network.

Firewall settings

Set whether to allow Event Notify and Sampling Function (UDP:0x501F) in Firewall settings.
If unregistered, the event notification and sampling function of the ETH device will not be available.
If registered, the port on the PC side will be released and connections from the ETH device UDP:0x501F will be allowed.

When an ETH device is detected, the ETH device UDP:0x501F is allowed by default.

Other settings

GPIO number to output interrupt notification signal

For the HAT size CPI-CNT-3201I, you can specify the GPIO number that outputs the interrupt notification signal.

The GPIO number must match both the DIP switch specification on the CPI-CNT-3201I and the Setup Tool (configuration).

For details, please refer to [Setting the GPIO number that outputs the CPI-CNT-3201I interrupt notification signal].