[#]:Select device

Select the device for which you want to change the DeviceName.
At the "Please input" prompt, specify the number in [] of the target device.
Enter the number of the target device, information about the selected device will be displayed, and wait for command selection.

The commands that can be executed depend on the target device.

Change DeviceName

Select the command "[1]:Change DeviceName" to change the DeviceName of the selected device.
Select the command "[m]:Back to menu", the (Devices list) menu will be displayed again, and wait for command selection.
It can not have the same name as any other device.
When specifying a device from an application, specify this DeviceName.

Network settings

Configure the wired LAN network

920MHz wireless settings

Make settings related to 920MHz wireless communication.

Item name	Description
Wireless Channel	Set the channel used for 920 MHz band communication.
PAN ID	Set the PAN ID used for 920 MHz band communication. It is fixed to 0 when Device Mode of "Other settings" is set to "CONPROSYS mode"
Tx Power	Set transmission output. Normally, it uses the initial value of 20 (mW).
Bit Rate	Set the bit rate (communication speed). Normally, it uses the initial value of 100 (kbps).
Request Timeout	Set the communication timeout time between the master unit and slave unit. Normally, it uses the initial value of 3000 (msec).
Aging Time	Set the connection maintenance time between the master and slave. The initial value is 600. Normally, use the default value, but if you have changed Data Interval setting, We recommend changing the value to about 10 times Data Interval setting. Also, when changing this setting, it is recommended to set the same setting for the master unit. Settable range: 60 to 36000 (sec)
Encryption Key	Set the encryption key used for communication between the master unit and the slave unit. It is specified with 32 digit hexadecimal number, and the initial value is all 0. In order for the master unit and the slave unit to communicate, the same value must be set in Encryption Key.
Priority Route	If there is a communication route you want to prioritize, specify Gateway if you want to communicate directly with the master unit, and specify the target Device ID if you want to pass through other slave device. - Disabled Do not specify a preferred route - Gateway In an environment where the slave device can directly communicate with the master unit, the master unit has priority. - ID: 0-127 Specify the slave unit that gives priority to relaying.

Other settings

項目名	概略
Unit ID	When using the same product, it is necessary to set the Unit ID uniquely.
Device ID	When using several slave units with one master unit, it is necessary to set the Device ID uniquely.
Data Interval	Sets the time interval at which the input value of this device is transmitted to its master unit.
Device Mode	Normally it is used in the initial value "Wireless I/O mode". Select "CONPROSYS mode" when using it as a slave of our product CONPROSYS series.
Modbus Function	Set enable / disable of Modbus function. It is compatible with Modbus TCP Slave and can collect and control data from upper communication equipment with Modbus master function. The default value is Enabled.